Carrier 38AUZ Specifiche Pagina 100
- Pagina / 218
- Indice
- SEGNALIBRI
Valutato. / 5. Basato su recensioni clienti
Guide Specification for FCU/CU-6
Project: ~Untitled68 08/19/2014
Prepared By:
Guide Specifications – Fan Coils – Fixed Speed
Guide Specifications
for ________________________________.
(See the most recent edition of publication ___________________for data for the specific model to be specified).
Furnish and Install
_________________ direct expansion fan coil(s) equipped with cooling control kit and _____(with)
_____(without) electric heater in the location and manner shown on the plan. Unit shall operate properly in _____(vertical upflow)
_____(horizontal right) _____(horizontal left) _____(vertical downflow) position and is to be installed with ductwork. Total
cooling capacity shall be ______ Btuh or greater, and sensible heat capacity shall be _____Btuh or greater, at conditions of _____
cfm, _____degree F wb _____degree F db air entering unit, and a coil refrigerant temperature of _____ degree F.
Efficiency
shall be __________ when matched with outdoor unit _____________ (per ARI ratings certification).
Unit enclosure
shall be insulated with a 1 inch foil faced, high density, R4.2 insulation, and be constructed of prepainted galvanized
steel. Large front service access panels shall provide easy access to all components. Unit shall be _____ (factory), _____ (field)
equipped with reusable type filters. Filter shall be _____inches (X) _____ inches.
Fan
shall be forward curved with double inlet, mounted on motor shaft, dynamically and statically balanced. The fan shall deliver
_____ cfm with _____ in. wg external static pressure operating at _____ hp. Fan-motor assembly shall be removable for service.
Blower motor shall be induction type, of _____ hp.
Cooling coil
shall have a face area of not less than _____sq. ft. and be constructed with brazed copper tubing with aluminum lanced
fins. Coil shall have TXV ( thermal expansion valve); refrigerant line fittings which permit braze connections. Condensate pans shall
be equipped with primary and auxiliary drain connections with brass inserts, sloping, with minimal standing water retention.
Refrigerant to be used will be _____(R-22) _____(R-410a).
Blower controls
include control board with time delay relay, a 5 amp replaceable automotive-type circuit protection fuse, and motor
speed tap selection terminal (SPT).
Electric heater
___________________
shall be _____(factory) _____(field) installed wired for_____(single)_____(multiple) supply
circuit and _____(single)_____(3-phase) operation on fixed speed fan coil units. Standard heater control wiring shall be single stage
with optional multiple staging capability. All heaters shall be equipped with thermal overload device, current overload for heater
above 10 kw.
Cooling control system
includes 40-VA control circuit (24 v) transformer, with replaceable 5 amp blade-type auto fuse. Low voltage
connections shall be point-to-point “wire” connections.
Maximum dimensions:
length _______ inches; width ______inches; height ______ inches.
Electrical requirements:
_________ volts, _____(single phase) _____(three phase) , frequency _____(60) _____(50) hertz.
Residential Carrier Products Bldr 1.19p Page 8 of 8
- SUMMARY 8
- DX Coil Performance Summary 14
- AHRI Standard 260 16
- Quality Pleat 26
- Unit Report For CU-1,2 43
- Acoustic Summary For CU-1,2 46
- Certified Drawing for CU-1,2 47
- Prepared By: 03:47PM 48
- Copyright 2011 Carrier Corp 51
- Edition Date: 03/11 51
- Replaces: GS-38AU-03PD 51
- Unit Report For CU 3-5 84
- Acoustic Summary For CU 3-5 87
- Certified Drawing for CU 3-5 88
- Unit Report For FCU/CU-6 93
- Acoustic Summary For FCU/CU-6 95
- Prepared By: 100
- Unit Report For AHU CU 7 8 101
- System Performance 102
- System Parameters 102
- Electrical Data 102
- DIMENSIONS - - ENGLISH 104
- DIMENSIONS (cont.) 105
- DIMENSIONS 106
- Unit Report For AHU CU-9 107
- Acoustic Summary For AHU CU-9 109
- PRODUCTS 113
- Unit Report For AHU CU 10 115
- Unit Report For AHU CU 12 121
- HVAC Submittal Cover Sheet 129
- Unit Report For RTU-1 130
- Certified Drawing for RTU-1 131
- Performance Summary For RTU-1 132
- HVAC Guide Specifications 135
- Guide Specification for RTU-1 136
- ST Michael the Archangel 139
- Dimensions: PKA-A12HA 140
- Dimensions: PUY-A12nHA3 141
- A/E confirm manufacturer and 143
- Flat Roof at Kitchen 143
- A/E Confirm 143
- A/E Verify 158
- Request for 178
- Information 178
- 10/28/2014 179
- Brian Rucks 179
- Project Architect 179
- 490 Arnold Mill Rd 206
- Woodstock, GA 30188 206
- FOR SUBMITTAL 206
- Product Bulletin 207
- Code No. LIT-12011400 207
- Wireless Communication 208
- Component Quantities 209
- 10 m (30 ft) Through Walls 210
- 30 m (100 ft) Open Space 210
- Recommended Signal Range 210
- Component Descriptions 211
- FAN Yes Yes 213
- HEAT Yes No 213
- COOL Yes No 213
- AUX HEAT No Yes 213
- HEAT PUMP No Yes 213
- Ordering Information 215
- Repair Information 215
- 215
- TEC20 Wireless Coordinator 216
- Building Efficiency 218
Prodotti e manuali riguardandi Climatizzatori a split Carrier 38AUZ
(16 pagine)© 2020, manymanuals.it. Tutti i diritti riservati | 0.045 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale