Carrier operating and maintanance Manuale dell'Operatore Scaricare il pdf (Pagina 26)

Rev. __________

Date _________

2.8

3. Tilt

Raise the tilt control lever (second lever), raising the forward end of the

deck until the rear bumper rests firmly on the ground.

4. Roll

Raise the roll handle (first lever) and the deck will slide back. Continue this

operation until the approach plate of the deck has contacted the ground.

Make sure that the rear bumper and the approach plate are both in firm

contact with the ground before loading. There should be an equal weight

distribution between the rear bumper and the end of the deck.

5. Tilt (upper deck)

Raise the tilt control lever (fifth lever) for the upper deck. This will raise the

front end of the upper deck, raise fully. Free-spool the upper winch and

hook up to the equipment to be loaded.

**Note that tilting the upper deck will leave a gap between the

upper and lower decks.

6. Winch (upper deck)

Using the upper deck winch lever (sixth lever), winch the load up the lower

deck approximately three quarters of the way.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 43 44

Nessun commento

Carrier operating and maintanance Manuale dell'Operatore Pagina 26