Carrier 558D Manuale Utente Scaricare il pdf (Pagina 6)

Dorner Mfg. Corp. 6 851-558 Rev. D

Fixed and Adjustable Height Stands

Installation

3. Attach crossmember (Figure 5, item 1) to stand leg

(Figure 5, item 2) with button screws (Figure

5, item 3). Do not tighten.

Figure 5

4. Repeat step 4 for opposite stand leg. Make sure to locate

the red warning area (Figure 3, item P) on the same ends

of stand legs (Figure 5, item K).

5. Upright stand and locate and space crossmember(s)

(Figure 6, item 1) evenly along stand leg (Figure

6, item 2). Tighten crossmember button screws (Figure

6, item 3) to 150 in–lb (17 N–m).

Figure 6

6. On the end with red warning area (Figure 7, item 1)

install one (1) hex nut (Figure 7, item 2) into each

outside stand leg (Figure 7, item 3) t–slot.

Figure 7

7. Slide boot (Figure 8, item 1) onto stand leg (Figure

8, item 2). Align hex nuts (Figure 8, item 3) and boot

holes and attach boot with button screws (Figure

8, item 4). Tighten button screws to 150 in–lb (17 N–

m). Repeat for opposite leg.

Figure 8

WARNING

Failure to secure screws (Figure 6, item 3)

may cause conveyor sections to drop down

causing severe injury.

TIGHTEN SCREWS (Figure 6, item 3) AFTER

ADJUSTMENT.

WARNING

Failure to secure screws (Figure 8, item 4)

may cause conveyor sections to drop down

causing severe injury.

TIGHTEN SCREWS (Figure 8, item 4) AFTER

ADJUSTMENT.

IMPORTANT

Red warning area (Figure 8, item 5) must be

under boot (Figure 8, item 1) after assembly.

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Nessun commento

Carrier 558D Manuale Utente Pagina 6